If you wish to use a replacement headset you must re-subscribe as follows: The headset and the base unit are supplied subscribed to each other. Plug the AC power back in to the charging base. Unplug the AC power from the bottom of the charging base for five seconds.Ĩ. The yellow light will blink a second time.ħ. Press and hold the call control button (only) again. When the yellow light on the headset blinks, release all buttons.ĥ. (All of these buttons are on the headset.)Ĥ. Simultaneously press & hold the call control button & the volume + and – buttons for 5 seconds. Take the headset out of the charging base.ģ. Check the switch on the right side of the charging base. If you experience acoustic or power problems with Plantronics CS70 or Plantronics CS70N, try a system reset:ġ. An agent can help you find the correct lifter. You may also need an HL1 if the phone is set at an extreme angle. The HL10 needs a flat edge for placement. If the phone has a curved edge on the left, you will need an HL1. However, depending on the shape of the phone, an HL1 may be needed instead of the HL10. Make sure the wireless unit (not the lifter) is connected via a “handset port” on the phone and not a “headset port”. However if you phone did not require this before installation you may have it installed incorrectly. If your phone requires you to press a button to receive a call, you will still have to do so. This will allow you to remotely pick up the hand receiver for incoming calls. In addition you will need to purchase the * Plantronics HL10 Handset Lifter accessory. You will first need to purchase or already have a Plantronics CS70 or CS70N wireless. How can I answer a call remotely (away from the phone) with a headset? If you are using the HL10 handset lifer you can enable the IntelliStand feature to senses when the headset has been removed or placed into the base unit which automatically activates the Handset Lifter and enabling headset/handset mode to answer or end the call. There is a switch on the right hand side of the base which is your the IntelliStand feature. The Intellistand feature may be activated. My handset lifter moves when I remove the CS70 wireless headset from the base. The recommended setting for most phones is 1. If this doesn’t fix the echo, try moving the configuration dial on the left side of the charging base.
Cs70n plantronics wireless headset plus#
You can fine tune this setting with the plus (+) and minus (-) buttons on the back of the charging base. A is the lowest and D is the highest setting.
The master transmit controls of the headset are the ABCD switch settings on the bottom of the base. If you still hear an echo, adjust the volume of the headset itself.
First, try lowering the volume of the telephone. What should I do?Įcho is usually caused by the transmit (speak) level on the unit being set too high. I hear an echo/side tone on my Plantronics CS70 wireless headset.
Cs70n plantronics wireless headset install#
How do I install the Plantronics CS70/CS70N wireless headset? (see picture below)
0 kommentar(er)
